Diamond Systems’ Emerald-MM PC/104 module gives you 4 serial ports operating at speeds up to 115kbps. In RS-232 mode, the full complement of standard PC serial port signals (8 signals + ground) are provided for each port and are grouped onto two 20-pin headers (2 ports per header). In RS-422 mode, Signals RX+, RX-, TX+, and TX- are provided, along with ground. In RS-485 mode, signals TX+/RX+ and TX-/RX- are provided, along with ground.
5V-only operation and -40 to +85C industrial operating temperature range are standard features. The industry-standard 16C554 UART is compatible with all popular embedded operating systems.
Emerald-MM from Diamond Systems offers more interrupt level and I/O address options than other quad serial port modules. Therefore, integrating the board into your computer system is a simpler task. Eight different I/O address combinations and 10 different interrupt levels are available.
To help conserve ISA bus interrupts, any number of ports can share the same interrupt level. If you have two boards in one system, both boards can share the same interrupt level as well. An interrupt status register is provided to indicate the status of each serial port’s interrupt request signal.
Interrupt levels are individually selectable for each port. The available interrupt levels are 2, 3, 4, 5, 6, 7, 10, 11, 12, and 15. In addition, a 1K Ohm pulldown resistor is provided for each port.
A single interrupt level can be shared by 2, 3, or 4 ports on one board and can even be shared by more than one board in the system. To enable interrupt sharing, set two or more interrupt level jumpers to the same level and pull out all but one pulldown resistor jumper.
|Brand & Model
|Diamond Systems EMM-4M-XT
|4-Port RS-232/422/485 Serial PC/104 Wide Temperature Module
|Number of ports
|RS-232, RS-422, RS-485
|Individual jumper selection for each port
|Maximum baud rate
|5, 6, 7, or 8 data bits; Even, odd, or no parity
|Short circuit protection
|All outputs protected against continuous short circuit
|Input voltage swing
|Output voltage swing
|±5V min, ±7V typical
|RS-422, RS-485 Protocols
|-0.2V min, +0.2V max input threshold
|+1.0µA max (Vin = 12V), -0.8µA max (VIN = -7V)
|Differential output voltage
|2.0V min (RL=50Ω)
|High/low states differential output voltage symmetry
|2 20-position (2×10) .1″ pitch right-angle pin headers
|3.55″ x 3.775″ / 90x96mm (not including I/O connector pins)
|80mA typical, all outputs unloaded
|8-bit and 16-bit bus headers are installed; 8-bit databus width