Neousys MezIO-G4P 4-Port Gigabit 802.3at PoE+ MezIO Module for Cameras and Sensors

A vision or surveillance system with four cameras normally needs a PoE switch or injectors beside the computer, plus the cabling and power supply to go with them. Powering the cameras straight from the computer removes that layer from the cabinet. The MezIO-G4P is the PoE+ module in the Neousys MezIO-G4/G4P series, a four-port Gigabit 802.3at PoE+ MezIO module built for that job.

It adds four Gigabit Ethernet ports, each on its own Intel I210 controller, compliant with IEEE 802.3at-2009 PoE+ and delivering up to 25.5 W per port. Jumbo frames up to 9.5 kB are supported, and each port runs over CAT-5e or CAT-6 cable up to 100 m. With a dedicated controller per port, each camera has its own Gigabit link. If the connected devices have their own power, the MezIO-G4 offers the same four ports without PoE+.

We fit the MezIO-G4P inside the Neousys system on its high-speed board-to-board connector with three-point mezzanine mounting, then configure the ports and test PoE+ output before the system ships. The MezIO-G4P only works in the PoE+ build of the host, such as the Nuvo-9006E/P/DE/LP, Nuvo-11006E/LP and Nuvo-11160GC PoE+ models, so we confirm the host model with your quote. Compatible families are the Nuvo-9000, Nuvo-11000, Nuvo-11160GC, Nuvo-9160GC and Nuvo-9166GC series.

Each system has one MezIO interface, so the MezIO-G4P takes that position. Where the project needs more USB devices rather than powered cameras, the MezIO-U4-50 adds four USB 3.1 ports on the same interface. Send us the camera models and their power class and we can check the PoE+ budget against the system before we build.