Skip to main content
Contact Us
Diamond Systems Partner

Diamond Systems SabreNet-12000-200 12 Port Gigabit Managed Rugged Switch With Layer 3 Software, MIL-Grade Power Supply and High-Profile Case

The SabreNet-12000-200 is the MIL-grade power build in the Diamond Systems SabreNet-12000 series, a sealed 12-port gigabit rugged Ethernet switch with Layer 3 software and an isolated supply compliant with MIL-STD-461, MIL-STD-704 and MIL-STD-1275. It suits vehicle and aircraft power buses.

  • 12 Gigabit Copper Ports: Twelve 10/100/1000Base-T ports sit on two MIL-DTL-38999 connectors in groups of four and eight, so each cable run stays sealed.
  • Layer 3 Software: Diamond’s embedded IStaX routing and switching software lets the switch route between network segments as well as switch traffic within them.
  • Isolated MIL-Grade Supply: A power supply based on Diamond’s JMM-7500 gives MIL-STD-461, MIL-STD-704 and MIL-STD-1275 compliance with 500 V input-to-output isolation.
  • Two Management Paths: A web interface on any Ethernet port and a local RS-232 port on the four-port connector give both in-band and out-of-band access.
  • Sealed Wide-Temperature Case: An enclosure with an IP67 design and a -40 to +85 °C operating range suits installations exposed to dust, water and temperature extremes.
View SabreNet-12000 Series
Thermal Dissipation: FanlessFanless
Operating Temperature: Extended TemperatureExtended Temp
Operating Temperature: Wide Temperature [-40 to 85°C]Wide Temp
USA Support Team: +1 407 214 9446 Call
Select section
  • Overview
  • Specifications
  • Downloads

SabreNet-12000-200 Overview

Vehicle and aircraft power buses carry surges, spikes and dropouts that a filtered supply alone may not ride through, so some programs call for full isolation between the power input and the electronics. The SabreNet-12000-200 is the MIL-grade power build in the Diamond Systems SabreNet-12000 series: a complete rugged Ethernet switch that Diamond builds around its EPS-12000 board-level switch, with an isolated power supply and no PTP timing.

It carries 12 10/100/1000Base-T copper Ethernet ports, arranged in groups of four and eight on two MIL-DTL-38999 connectors, so every link enters the case through a sealed circular connector rather than an RJ-45 socket. Diamond’s embedded IStaX Layer 3 routing and switching software runs on the switch, and you manage it through a web interface on any of the ports or through a local RS-232 port on the four-port connector. Diamond can also customize the software branding and the connector arrangement.

The Layer 3 software routes between subnets as well as switching within them, which helps where a network is split into segments for sensors, mission computers and communications. Inside, Diamond’s EPS-12000 pairs an EPSM-10GX switch module with a carrier board that holds the magnetics and the power circuits. The SabreNet-12000-220 adds IEEE-1588 PTP to this build, and the SabreNet-12000-100 uses a MIL-STD-461 filter in a shorter case. Our guide to Layer 2 and Layer 3 switches explains when routing inside the switch helps.

The power supply is based on Diamond’s JMM-7500 and provides compliance with MIL-STD-461, MIL-STD-704 and MIL-STD-1275, with 500 V isolation between input and output. This build uses the taller of the two enclosures. The case has an IP67 design and the switch operates from -40 to +85 °C. Diamond publishes a shock and vibration test report for the SabreNet-12000, and a lab bench-grade external cable kit lets you run it on the bench.

SabreNet-12000-200 Specifications

Overview
Brand & ModelDiamond Systems SabreNet-12000-200
FeaturesEmbedded
Fanless
Managed Ethernet Switch
Rugged
I/O
Serial1x Serial Ports
1x RS232 [MIL-STD]
Networking
Switching LayerLayer 3
Switch TypeManaged
Ethernet Ports12x 10/100/1000 BASE-TX [MIL-STD]
Number of Ethernet Ports12x Ethernet Ports
Networking StandardsIEEE 802.1D Spanning Tree Protocol
IEEE 802.1Q VLAN
IEEE 802.1s Multiple Spanning Tree Protocol
IEEE 802.1w Rapid Spanning Tree Protocol
IEEE 802.1X Port-Based Network Access Control
IEEE 802.3 10BaseTx Ethernet
IEEE 802.3ab 1000BaseTx Gigabit Ethernet
IEEE 802.3ad Link Aggregation
IEEE 802.3u 100BaseTx Fast Ethernet
Power
Power Input9-60V DC Input [MIL-STD]
Environmental Conditions
Thermal DissipationFanless Passively Cooled Chassis
Operating Temperature-40°C to 85°C [-40°F to 185°F]
Storage Temperature-40°C to 85°C [-40°F to 185°F]
Ingress ProtectionIP67
IP67 [Dustproof, Protection against immersion in water up to 1 meter for 30 minutes]
ShockMIL-STD-202G
MIL-STD-810G
VibrationMIL-STD-810G
EMCMIL-STD-461G
CertificationMIL-STD-1275
MIL-STD-704
MIL-STD-461
Mechanical Properties
Chassis MaterialAluminum
Dimensions163mm x 137mm x 85mm (6.40” x 5.40” x 3.30”)

Official Diamond Systems USA Distributor

Things Embedded is an official Diamond Systems USA distributor, supplying the SabreNet-12000-200 for USA defense and vehicle programs. Within the Diamond range the EPS-12000-CM offers the same switch core as a board for your own enclosure, and the RAPTOR-EPSILON is a smaller eight-port sealed switch.

The SabreNet-12000-200 sits among our rugged Ethernet switches and our full range of network switches for harsh settings. Where a sealed 12-port network runs from a vehicle or aircraft bus and needs an isolated supply, this is the build to specify.

Shop Diamond Systems

Consult. Design. Integrate.

Things Embedded is a leading USA supplier of industrial computing and edge AI systems. We combine technical expertise with a collaborative approach to deliver optimal solutions for your application. Whether it’s an off-the-shelf platform or a custom design, we stay at the forefront of the latest technologies to ensure your success at the edge. Our team works closely with you from concept through deployment, providing guidance, engineering support, and integration expertise every step of the way.

Connect with our solutions experts today to review your requirements and find the ideal solution fit for your application.

Services
Send Inquiry